‘Fine tune’ is an expandable/collapsible section, featured at the bottom of the display area; it is available when the Milling diagram or the Heatmap is being displayed.
| Info |
|---|
Use the scroll bar to scroll through the Fine tune parameters. |
The Fine Tune section contains a set of parameters that fall into one of two categories:
Inputs - the parameters with which the Machinist will most commonly interact.
Outputs - these parameters are more a source of information and are concerned with the affects of the machining operation.
All of the Fine tune parameters are defined with the Glossary of Terms.
Fine tuning sliders
| Info |
|---|
The units displayed for the sliders could be imperial or metric, depending on the |
‘session settings’ (see |
Cutting Parameters Layout (#9)). |
Each parameter is fine tuned via a slider, which has following layout and features.