‘Fine tune’ is an expandable/collapsible section, featured at the bottom of the display area; it is available when the Milling diagram or the Heatmap is being displayed.
| Info |
|---|
Use the scroll bar to scroll through the Fine tune parameters. |
The Fine Tune section contains a set of parameters that fall into one of two categories:
Inputs - the parameters with which the Machinist will most commonly interact.
Outputs - these parameters are more a source of information and are concerned with the affects of the machining operation.
All of the Fine tune parameters are defined with the Glossary of Terms.
Fine tune sliders
| Info |
|---|
The units displayed for the sliders could be imperial or metric, depending on the ‘session settings’ (see Cutting Parameters Layout (#9)). |
Each parameter is fine tuned via a slider, which could have any of the features shown in the following diagram:
The following table details each of the slider’s features.
# | Name | Description | How to usechange the value |
|---|---|---|---|
1 | Lower constraint adjuster | The lowermost permitted value for the parameter. | Click and drag the value to the left or right. |
2 | Current value | The recommended setting based on:. | Changing any of the following may dynamically affect the current value.
Double-click In addition, the value can be changed directly be double-clicking the value and amend it to one within the lower and upper constraints manually entering a new one. |
3 | Upper constraint adjuster | The uppermost value for the parameter. | Click and drag the value to the left or right. |
4 | Reset constraints | Resets the upper and lower constrains to their default values. | Click to reset. |
5 | Lock value | Locks/Unlocks the parameters values. | Click to switch between lock and unlock. |