Operation inputs
The ‘operation’ has one of two possible sources:
Original Fusion Browser ‘operation’ - a representation of the operation toolpath that you selected (right-clicked) to open Cutting Parameters (see the screenshot to the right).
Operation pop-up - you can replace the original operation with one selected from the pop-up (see below).
| Info |
|---|
On clicking the Operation tab, the Operation pop-up appears (see below). |
Operation pop-up
The Operation pop-up contains an operation-level representation of the Fusion Browser (as shown in the following example screenshots).
How to change the selected operation
Within the Operation pop-up, take the following steps:
Click on one of the options in the pop-up.
The content of the Operation input tab changes immediately to the selected operation.
Click on any of the input tabs (do not click Close)
The selected material is automatically saved.
The Operation pop-up closes.
| Info |
|---|
Some of the operations listed in the operation pop-up are greyed out (and cannot be selected) because the operation:
|