Machine input
The machine shown in the Machine input tab’s header is the one you originally selected for Choose Machine in CAM Assist , it was used to generate the toolpath strategy.
| Note |
|---|
The machine cannot be changed within Cutting Parameters but its properties can be changed within the Machine pop-up (see below). |
Machine properties
The properties of the chosen machine have one of two possible sources:
Original CAM Assist ‘Machine Properties’ (see the screenshot to the right) - the properties that you used to generate the toolpath strategy shown in the Fusion Browser .
| Info |
|---|
On clicking the Machine tab, the Machine pop-up appears (see below). |
Machine pop-up
| Info |
|---|
On clicking the |
‘Machine' input tab, |
its pop-up |
covers the Display Area (see |
the screenshot to the right). |
Machine pop-up
The Machine pop-up contains the same machine properties that are available within CAM Assist The unit of measurement used in the pop-up can be changed via the ‘Session Settings’ cogwheel (see Cutting Parameters Layout- Features and Functionality (#10)).
How to change the machine’s properties
Within the Machine pop-up, take the following steps:
Change the property value using either/both of the following methods:
Enter a value directly into the textbox.
Use the up-down control to increase-decrease the value by 1.
Click on any of the input tabs (do not click Close)
The new property values are automatically saved.
The Machine pop-up closes.
| Note |
|---|
The up-down button increments/decrements by integers, so if the button is used, it will remove any decimal accuracy for the value being changed. |
