The ‘Setup orientation’ is an expandable/collapsible section of the General Tab that contains an entry for each Machine Group that has been created for is part of the selected part.However, the part’s setup.
Layout and content
The layout/content of the ‘Setup orientation' is dynamic and section depends on the choices you make in the ‘General’ section for the following:
Machining mode - CAM Assist provides two modes:
3 Axis
3+2 Axis
Machining direction (displayed when the ‘Machining mode’ is 3+2 Axis) - CAM Assist provides the following options:
Aligned to X, Y, Z axes
User-defined
Automatic
The following screenshots show the two possible layouts for the ‘Setup orientation’ section and when they are used.
The layout below is used for:
| The layout below is used for:
|
Info |
---|
For details of these content changes and how |
...
to use the features of both layouts, see Machining Modes in the ‘How-to Guides’. |