CAM Assist provides multi-file support for your Siemens NX parts.
The support provided falls into two categories, as shown in the Multi-file support section of the Setup tab.
The Multi-file support section contains two features, exposed via checkboxes:
Use additional .prt file
Import finished faces
These features are detailed below.
Using additional .prt files
| Info |
|---|
In order to use this feature, you need to have at least two part files open in the current active Siemens NX session. |
The following step-by-step instructions provide guidance on how to use ‘additional .prt files’, using CAM Assist Demo Part 1.
As seen in the following side-by-side screenshots, the part has been split into two workpieces.
| Tip |
|---|
You can magnify any image in this User Guide by clicking on the image. |