The ‘Operation’ input tab contains a Fusion Browser-like structure, which it gets from one of two sources:
Original Fusion Browser ‘operation’ - a representation of the toolpath that you selected to open Cutting Parameters (see the screenshot to the right).
Operation pop-up - changes made within the Operation pop-up (see below) that appears when clicking on the tab (see below).
Operation pop-up
| Info |
|---|
On clicking the ‘Operation’ input tab, its pop-up covers the Display Area (see below). |
The pop-up contains an operation-level representation of the Fusion Browser (as shown in see the screenshots below above and to the right for comparison).
How to change the selected operation
Within the Operation pop-up, take the following steps:
Click on one of the operations in the pop-up.
The content of the Operation tab changes immediately to the selected operation.
Click on the
button in the top-right of the pop-up.The selected operation is automatically saved.
The Operation pop-up closes.
| Info |
|---|
Some of the operations listed in the operation pop-up are greyed out (and cannot be selected) because the operation:
|