The machine shown in the Machine input tab is the one you originally selected for Machine in CAM Assist to generate the toolpath strategy.
| Note |
|---|
The machine cannot be changed within the Cutting Parameters Explorer but its properties can be changed within the Machine pop-up (see below). |
Machine pop-up
| Info |
|---|
On clicking the ‘Machine' input tab, its pop-up covers the Display Area (see the screenshot to the right). |
The Machine pop-up contains the same machine properties that are available within CAM Assist. The unit of measurement used in the pop-up can be changed via the ‘Session Settings’ cogwheel (see Cutting Parameters - Features and Functionality (#11)).
How to change the machine’s properties
Within the Machine pop-up, take the following steps:
Change the property value using either/both of the following methods:
Enter a value directly into the textbox.
Use the up-down control to increase-decrease the value by 1.
Click on the
button in the top-right of the pop-up.The new machine property values are automatically saved.
The Machine pop-up closes.
| Note |
|---|
The up-down button increments/decrements by integers, so if the button is used, it will remove any decimal accuracy for the value being changed. |
