The ‘Operation’ input tab contains a Geometry View-like structure, which it gets from one of two sources:
A representation of the Geometry View, using Setup names as they appear in CAM Assist - this is based on the operation that you right-clicked to open the Cutting Parameters Explorer (see the screenshot to the right).
Operation pop-up - the operation you selected within the Operation pop-up (see below).
Operation pop-up
| Info |
|---|
On clicking the ‘Operation’ input tab, a pop-up covers the Display Area (see below). |
The pop-up contains a representation of the operation that was used to open the Cutting Parameters Explorer: in the ‘Operation’ pop-up you can change that operation to another.
How to change the selected operation
Within the Operation pop-up, take the following steps:
Click on one of the operations
The content of the Operation input tab changes immediately to the selected operation.
Click on the
button in the top-right of the pop-up.The selected operation is automatically saved.
The Operation pop-up closes.
| Info |
|---|
Some of the operations listed in the operation pop-up are greyed out (and cannot be selected) because the operation:
|
