Versions Compared

Version Old Version 16 New Version 17
Changes made by

Kevin Strider (Unlicensed)

Kevin Strider (Unlicensed)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Expand
titleClick to show/hide the details of the hotfix for v1.11.1

  • Fixed an issue that causes caused Fusion 360 to hang if the authentication page (shown during CAM Assist installation) is closed.

  • Improve Improved the tooltip for ‘Select Select roughing directions’ directions for the 3+2 machining mode ‘By Setup’

...