Versions Compared

Version Old Version 18 New Version 19
Changes made by

Kevin Strider (Unlicensed)

Kevin Strider (Unlicensed)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  • Fixed some minor cases where CAM Assist doesn’t run after installation

  • Fixed a minor issue around V1.10 of CAM Assist appearing as an outdated version

  • Fixed further errors around unsupported hole types

Hotfix v1.11.1

Expand
titleClick to show/hide the details of the hotfix for v1.11.1

  • Fixed an issue that caused Fusion 360 to hang when the authentication page (shown during CAM Assist installation) is closed.

  • Improved the tooltip for Select roughing directions for the 3+2 machining mode ‘By Setup’

...

v1.10.0

Release date: 10th November 2023

...