Operation inputs
The Operation
The ‘operation’ input tab’s header contains a tree-like structure that reflects the structure of the Fusion Browser.
The information has The ‘Operation’ input tab contains a Fusion Browser-like structure, which it gets from one of two sources:
Original Fusion Browser ‘operation’ - a representation of the operation toolpath that you selected to open Cutting Parameters (see the screenshot to the right).
Operation pop-up - on clicking changes made within the Operation tab, the Operation pop-up (see below) that appears when clicking on the tab (see below). If an option is selected from the
Operation pop-up
Operation pop-up
The Operation| Info |
|---|
On clicking the ‘Operation’ input tab, its pop-up covers the Display Area (see below). |
The pop-up contains an operation-level representation of the Fusion Browser
: in the ‘Operation’ pop-up you can change that operation to another.
How to change the selected operation
Within the Operation pop-up, take the following steps:
Click on one of the options operations in the pop-up.
The content of the Operation input tab changes immediately to the selected operation.
Click on any of the input tabs (do not click Close)the
button in the top-right of the pop-up.The selected material operation is automatically saved.
The Operation pop-up closes.
| Info |
|---|
Some of the operations listed in the operation pop-up are greyed out (and cannot be selected) because the operation:
|
