Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 43 Next »

image-20240405-134537.png

Operation inputs

The Operation

The ‘operation’ input tab’s header contains a tree-like structure that reflects the structure of the Fusion Browser.

The information has two sources:

  • Original Fusion Browser ‘operation’ - a representation of the operation toolpath that you selected to open Cutting Parameters (see the screenshot to the right).

  • Operation pop-up - on clicking the Operation tab, the Operation pop-up appears (see below). If an option is selected from the pop-up, it is shown in the tab information..

image-20240404-145658.png

Operation pop-up

The Operation pop-up contains an operation-level representation of the Fusion Browser (as shown in the following example screenshots).

image-20240403-132730.png
image-20240403-132636.png

How to change the selected operation

Within the Operation pop-up, take the following steps:

  1. Click on one of the options in the pop-up.

    • The content of the Operation tab changes immediately to the selected operation.

  2. Click on any of the input tabs (do not click Close)

    • The selected material is automatically saved.

    • The Operation pop-up closes.

Some of the operations listed in the operation pop-up are greyed out (and cannot be selected) because the operation:

  • Is not yet supported by Cutting Parameters - a list, at the top of the Operation pop-up, displays the operations that are supported.

  • Is not suitable for the selected tool.

  • No labels