CAM Assist provides multi-file support for your Siemens NX parts.
The Multi-file support section contains two features, exposed via checkboxes:
Use additional .prt file - enables you to compute toolpath strategies for multiple consecutive part files.
Import finished faces - enables you to compute a toolpath strategy for a multi-file part where the first part has finished faces and the second part requires the data for those finished faces.
Both of these features are detailed, below.
Using additional .prt files
In order to use this feature, you need to have at least two part files open in the current active Siemens NX session.
The part files must not have had a toolpath strategy computed for them.
The following step-by-step instructions provide guidance on how to use ‘additional .prt files’: to provide an example, CAM Assist’s ‘Demo Part 1’ is used.
Step-by-step instructions
Within Siemens NX:
Open the part (.prt) files for the multi-file setup.
Click on the tab for the ‘first’ part, to make it active.
The following side-by-side screenshots shows Demo Part 1 split into two workpieces.
You can magnify any image in this User Guide by clicking on the image.
Within CAM Assist:
Open the Setup tab.
Check the box for Use additional .prt file
It’s drop-down will contains the name of the second part file (as illustrated in the screenshot to the right).
Complete any other configuration within CAM Assist.
Click OK.
Importing finished faces
In order to use this feature, you need to have at least two part files open in the current active Siemens NX session.
The ‘first’ part file must contain data for a computed toolpath strategy.
This section is under development and will be updated soon.