‘Fine tune’ is an expandable/collapsible section, featured at the bottom of the display area; it is available when the Milling diagram or the Heatmap is being displayed.
Use the scroll bar to scroll through the Fine tune parameters.
The Fine Tune section contains a set of parameters that fall into one of two categories:
Inputs - the parameters with which the Machinist will most commonly interact.
Outputs - these parameters are more a source of information and are concerned with the affects of the machining operation.
All of the Fine tune parameters are defined with the Glossary of Terms.
Fine tune sliders
The units displayed for the sliders could be imperial or metric, depending on the ‘session settings’ (see Cutting Parameters Layout (#9)).
Each parameter is fine tuned via a slider, which could have any of the features shown in the following diagram:
The following table details each of the slider’s features.
# | Name | Description |
|---|---|---|
1 | Lower constraint adjuster | The minimum value for the parameter |
2 | Current value | The recommended setting based on:
|
3 | Upper constraint adjuster | The maximum value for this parameter. |
4 | Reset constraints | Resets the upper and lower constrains to their default values. |
5 | Lock value | Locks/Unlocks the parameters values. |