Machine tab content
The content of the Machine tab
...
has several sources:
The machine name is the one originally selected for Choose Machine in CAM Assist (see
...
below) that was used to generate the toolpath strategy shown in the Fusion Browser.
Note |
---|
The machine name can’t be changed within Cutting Parameters but its properties can. |
The
...
properties
...
of the chosen machine have one of two possible sources:
...
...
Original content - the ‘Machine Properties’ associated with the chosen machine within CAM Assist (see Machine Properties), as shown in the screenshot to the right (see below).
Machine pop-up - the values entered for the machine’s properties.
Machine pop-up
On clicking the Machine tab, the Machine pop-up appears in the display area.
The Machine pop-up contains the same machine properties that are available within CAM Assist The unit of measurement used in the pop-up can be changed via the ‘Session Settings’ cogwheel (see Cutting Parameters Layout).
How to change the
...
machine properties
Within the Machine pop-up, take the following steps:
Change the property value using either/both of the following methods:
Enter a value directly into the textbox.
Use the up-down control to increase-decrease the value by 1.
Click on any of the tabs (do not click Close)
The new property values are automatically saved.
The Machine pop-up closes.
Note |
---|
The up-down button increments/decrements by integers, so if the button is used, it will remove any decimal accuracy for the value being changed. |