...
On clicking the 2D ‘2D Milling diagram option in the Display Area (highlighted), the 2D Milling diagram is displayeddiagram’ option (the one on the left), it is displayed in the Display Area.
The 2D Milling diagram provides a dynamic illustration of the Cutting parameter recommendations. The left image represents the tool and the right image represents the tool’s operation on the part being machined.
Layout and features
To display the The 2D Milling diagram , select the ‘2D Milling diagram’ option, as has the layout and features shown in the following screenshot.
...
Layout
The 2D Milling diagram has two components:
The left image represents the cutting engagement.
The right image represents the z-place view of the machining process.
Features
Parameters
As annotated in the screenshot above, the 2D Milling diagram contains the following recommended parameters:
...
Each of these parameters can be amended in the Fine Tune section.
Dynamic adjustments
| Info |
|---|
As the cutting parameters inputs are changed, the 2D milling diagram is immediately updated. |
...
Tooltips
Hovering over any measurement displays a tooltip that contains the alternative unit system (to change unit system, see Cutting Parameters Layout [#10]).
...