Avoidance geometry ensures that machining operations do not occur in specific portions of the stock for the selected setup/workpiece, such as the space under the part or between the vise jaws.
These blocked out portions (Avoidance geometry) are different from fixture bodies. While fixture bodies MUST be avoided, the Avoidance Geometry is considered part of the stock and may be gouged in specific cases. For example, drilling a through-hole may pierce the avoidance geometry but not the fixture.
Fixture bodies also require clearance from any tool, whereas all roughing tools may touch the surface of the Avoidance geometry.
| Tip |
|---|
To magnify any image or screenshot, click on it. |
Avoidance Geometry options
The Avoidance geometry feature is available for each ‘Setup’ ‘Machine Group’ within the ‘Target Setups’ ‘Setup orientation’ section of the Setup General tab, as shown in the image to the right.
An important point to note is that using Avoidance geometry is completely optional, you could take either of the following actions:
Specify avoidance geometry for any of the Machine Groups that you have checked.
Don’t specify Avoidance geometry.
| Note |
|---|
If your part/model does not have a defined avoidance geometry body, then you will need to create it before you can use CAM Assist’s Avoidance geometry function (see the example, below). |
Using Avoidance geometry: an Example
The example used here (Avoidance Geometry Example.mcam) has a defined ‘Avoidance geometry’ body, which is a portion of the stock.
To use Avoidance geometry, take the following steps:
| Html macro | ||||
|---|---|---|---|---|
| ||||
<b>Within the <a href="https://cloudnc.atlassian.net/wiki/spaces/CAMMCUG/pages/120717498/Setup+Orientation" target="_blank">Setup orientation </b>section of the General tab</a>: |
| Panel | ||||||||
|---|---|---|---|---|---|---|---|---|
| ||||||||
Check the relevant Machine Group (see the example to the right). |
The 'Select avoidance geometries’ button (shown in the image to the right) is used to indicate that you want to specify the relevant portion of the model within Mastercam.
| Panel | ||||||||
|---|---|---|---|---|---|---|---|---|
| ||||||||
Click theSelect avoidance geometries (0) button. |
The number in brackets shows how many selections have been made.
Within Mastercam:
| Panel | ||||||||
|---|---|---|---|---|---|---|---|---|
| ||||||||
Click on the relevant body of the modelto indicate the avoidance geometry |
When you click on the model, the selected body is highlighted (as shown in the example, below).
| Note |
|---|
For avoidance geometry, you select the avoidance geometry body, not individual faces of the part. |
| Panel | ||||||||
|---|---|---|---|---|---|---|---|---|
| ||||||||
Press ESC when you’ve finished the selection |
Within CAM Assist:
Two things happen after you’ve clicked ESC (as shown in the image to the right):
The ‘Select avoidance geometry (0)' button is updated to show the number of selections: in this case, it is updated to 'Select avoidance geometry (1)’
A new button, ‘Clear selection’ is displayed.
Click it to remove all of your avoidance geometry selections for the associated Machine Group.
| Info |
|---|
You can specify avoidance geometries for any of the Machine Groups. |
| Panel | ||||||||
|---|---|---|---|---|---|---|---|---|
| ||||||||
Click |
On clicking 
, CAM Assist computes a toolpath strategy that respects the selected avoidance geometry, as shown in the following example screenshot.
