...
CAM Assist can now run in the background (see the General tab)
Before clicking ‘Run’ in CAM Assist, just check the ‘Enable background execution’ checkbox and you'll be free to continue other work within Fusion.
Note: you must not edit the targets setup(s) as it will have an impact on the result of CAM Assist's toolpath strategy computation.
Other features
Stock removal prediction.
Tool Use tab now supports T-slot cutters.
Connect all connected walls into a single toolpath op where possible.
Improvements
3+2 Machining mode (see the General tab)
Roughing Order - CAM Assist now respects the order (if you wish) of the faces you select when completing 3+2 roughing strategies.
Ability to select hole axis as a direction of tool orientation.
Rename ‘By Setup’ to ‘User Defined’ to improve user experience.
Other improvements
Tooltip improvement for ‘Avoidance Geometry’.
Update to documentation link.
UI changes to remove ‘360’ from the product.
‘Geometry selection’ is now next to ‘Machine Full Part’ checkbox.
Hide hole patching bodies by default to improve user experience.
The checkbox state of the 'Detail roughing' and 'Hole patching' is persistent.
Email in sign-up form is populated automatically based on Stripe / Autodesk authentication.
...