Page Comparison

...

The ‘Target setups' section of the General Tab contains an entry for each setup has been created for the selected part.

Layout and

...

content

The layout and content of the ‘Target setups' is section depends on the choices you make in the ‘General' section for the following:

• Machining mode - CAM Assist provides two modes:

  • 3 Axis

  • 3+2 Axis

• Machining direction (displayed when the ‘Machining mode’ is 3+2 Axis) - CAM Assist provides the following options:

  • Aligned to X, Y, Z axes

  • User-defined

  • Automatic

The following screenshots show the two possible layouts for the ‘Target setups’ section and when they are used.

...

The above layout below is used for the following: Machining mode= 3 Axis 3+2 Axis (Machining direction= Aligned to X, Y, Z axes) Image RemovedImage Added

The above layout below is used for the following: Machining mode= 3+2 Axis ( Machining direction= User-defined) Image Added