The 2D Milling diagram provides a dynamic illustration of the Cutting parameters. As the cutting parameters are changed as a result of
Layout and features
To display the 2D Milling diagram, select the ‘2D Milling diagram’ option, as shown in the following screenshot.
As annotated in the screenshot above, the 2D Milling diagram contains the following recommended parameters:
Depth of cut (Ap)
Spindle speed
Width of cut (Ae)
Chip load
Feed per tooth
Feed rate
Each of these parameters can be amended in the Fine Tune section.
Dynamic adjustments
The 2D Milling diagram is dynamically updated by changes to any of the following:
Aggression control sliders
Fine tune parameter settings