Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 11 Next »

Sections

The Tool Usages tab contains the following sections:

Tooltips

Tooltips contain useful information on the purpose and use of features within the Tools tab. To see a tooltip, just hover over a feature.

For more details on each of the above features, see below

image-20240704-121117.png

Face milling

image-20240704-154420.png

The Face milling section contains a ‘Facing operations’ checkbox that is used to configure CAM Assist to compute Facing operations (for Rouging and Finishing):

  • Checked - CAM Assist will compute Facing toolpaths using a Face Mill or End Mill to face off the part.

  • Unchecked - CAM Assist will not compute Facing toolpaths for the part.

Roughing

image-20240704-155204.png

The Roughing section contains a collection of controls that are used to configure CAM Assist to compute Roughing operations.

Feature

Details

How to Use

Bulk roughing

  • Checked - CAM Assist will compute Roughing toolpaths to efficiently remove the bulk of the stock material around the part.

  • Unchecked - CAM Assist will not compute any Roughing toolpaths.

    • Detailed roughing and Hole patching are unchecked and disabled.

    • You must manually create Roughing toolpaths to clear the stock for the Finishing operations.

The following features are only available if Bulk roughing is checked.

Detailed roughing

  • Checked - CAM Assist will compute detailed Roughing toolpaths that have a fine stepdown and ensure that freeform features are adequately roughed out.

    • Using this strategy can be computationally expensive and may involve longer toolpath generation times than other methods.

  • Unchecked - CAM Assist will not compute detailed Roughing toolpaths.

Click the checkbox to check/uncheck it.

Hole patching

  • Checked - CAM Assist will use ‘Bodies’ to fill in holes to prevent Roughing passes from attempting to cut into them.

    • This can be important for efficiency and ensuring surface finish and part tolerances.

  • Unchecked - CAM Assist will not prevent Roughing passes from cutting into holes.

Click the checkbox to check/uncheck it.

Wall

The wall stock to leave after roughing operations.

  1. Click in the textbox

  2. Amend the value as required

The new value is saved automatically.

Floor

The floor stock to leave after roughing operations.

  1. Click the textbox

  2. Amend the value as required

The new value is saved automatically.

Bulk roughing

Detailed roughing

Hole patching

This option is only available if Bulk roughing is checked.

Stock to leave after roughing operations

This option is only available if Bulk roughing is checked.

Finishing

Hole making

Deburring

  • No labels