'Tool' Input Tab

Tool header

The tool shown in the Tool input tab’s header is the one used for the currently selected operation (the one displayed in the Operation Input tab).

The tool cannot be changed within Cutting Parameters but some of its properties can be changed within the Tool pop-up (see below).

The properties of the tool have one of two possible sources:

Fusion Tool Library
Tool pop-up - you can replace some of the Fusion values with those specified in the pop-up (see below).

On clicking the Tool input tab, the Tool pop-up appears (see below).

Within the Tool pop-up, there are two types of properties:

Fusion-specified - properties that you cannot change (such properties have an asterisk at the end of their name)
User-specified - properties that you can change (see below).

The following table shows which properties can be changed and how to change them.

Property	How to change
Chip breaker	Click the required option (Yes/No/Unknown) - it will go grey.
Coating	Click the drop-down arrow and select one of the options. For a definition of the Coating options, see the Glossary listing.
Helix angle	You can do either/both of the following: Enter the value directly into the textbox. Use the up-down buttons to increment/decrement the value (the arrows appear when you the mouse pointer near ‘degrees’).
Radial rake angle	You can do either/both of the following: Enter the value directly into the textbox. Use the up-down buttons to increment/decrement the value (the arrows appear when you the mouse pointer near ‘degrees’).
Tool retention	Click the drop-down arrow and select one of the options.

For a definition of the terms used within Cutting Parameters, see the Glossary of Terms.