Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 9 Next »

Before continuing, if you’re not familiar with the Cycle Time Estimator, it’s recommended you take a look at the Introduction.

Features and Functionality

To magnify any image/screenshot, just click it.

The following screenshot shows the layout and features of the Cycle Time Estimator.

image-20240520-130210.png

As shown in the above screenshot, the layout for Cycle Time Estimator has the following features.

Feature

Description

Top banner

image-20240520-130434.png

The Cycle Time Estimator can be collapsed and expanded (in the same way as other aspects of Fusion’s user interface)

4 Tabs

image-20240520-130535.png

The Cycle Time Estimator presents its core features and functionality via a set of four tabs (as shown in the above screenshot):

  • Upload - enables you to:

    • Upload up to 10 Fusion part files (see Upload Tab).

    • Configure the machining environment.

  • Cycle Times Estimates - presents the results of the cycle time estimate, which is performed on clicking Run (see Cycle Time Estimates Tab).

  • Report - provides a summary report of the cycle time estimate, which is performed on clicking Run (see Report Tab).

  • Export - enables you to export any of the Cycle Time Estimates, as a CSV (comma-separated values) file, to a designated folder (see Export Tab).

Bottom banner

image-20240520-133535.png

Contains the following:

  • Run - creates a cycle time estimate, and a toolpath strategy, based on the specified ‘Options’, for each of the ‘Upload’ files.

  • Cancel - cancels and closes all choices made within the Cycle Times Estimator and returns to Fusion.

  • No labels