Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 18 Next »

The Machining mode drop-down in the General tab contains two choices: ‘3-Axis’ and ‘3+2 Axis’.

Once a Machine mode has been selected, the ‘General’ section of the General tab changes, as shown in the following screenshots.

image-20240501-150144.png

image-20240501-150106.png

The content of the ‘Target setups’ section of the General tab then changes based on the following choices:

  • Machining mode

  • Machining direction

For ‘how-to’ instructions on using the above options, see the following:

  • No labels