'Operation' Input Tab

operation_input.drawio.png

The ‘Operation’ input tab contains a Geometry View-like structure, which it gets from one of two sources:

  • A representation of the Geometry View, using Setup names as they appear in CAM Assist - this is based on the operation that you right-clicked to open the Cutting Parameters Explorer (see the screenshot to the right).

  • Operation pop-up - the operation you selected within the Operation pop-up (see below).

image-20240822-083045.png

Operation pop-up

On clicking the ‘Operation’ input tab, a pop-up covers the Display Area (see below).

The pop-up contains a representation of the operation that was used to open the Cutting Parameters Explorer: in the ‘Operation’ pop-up you can change that operation to another.

How to change the selected operation

Within the Operation pop-up, take the following steps:

  1. Click on one of the operations

    • The content of the Operation input tab changes immediately to the selected operation.

  2. Click on the image-20240610-121902.png button in the top-right of the pop-up.

    • The selected operation is automatically saved.

    • The Operation pop-up closes.

 

Some of the operations listed in the operation pop-up are greyed out (and cannot be selected) because the operation:

  • Is not yet supported by the Cutting Parameters Explorer.

  • Is not suitable for the selected tool.

Â