Finishing

The ‘Finishing’ section of the Advanced tab provides a granular level of control for specific aspects of the finishing toolpath.

How to Use

Click on one of the two options available for each aspect.

image-20240628-085813.png

Features

The following table describes each feature in the Finishing section, as shown in the above screenshot.

Option

Description

Option

Description

Finishing operation ordering

There are two options available:

  • Order by type - CAM Assist will separate floor and wall toolpaths into separate folders. This can make the program easier to understand, but can introduce additional tool changes if the same tool is used for both floors and walls.

  • Minimize tool changes - CAM Assist will produce floor and wall toolpaths in a single folder, ordered to minimize tool changes.

Finishing flat operation

The options available are:

  • 2D Area mill - where possible, use 2D mill; otherwise, use Horizontal.

  • Horizontal - use the 3D High Speed Horizontal strategy.

Finishing freeform operation

There are two options:

  • Waterline - use the Waterline strategy for finishing freeform operations.

  • Hybrid - always use Steep and Shallow operations.

Deburring tool type

There are two options available:

  • Ball mill - use ball mills to deburr sharp edges.

  • Chamfer tool - use chamfer mills to deburr sharp edges.